Oil pressure sensors – what are they for and how do they work?
Repairs

Oil pressure sensors – what are they for and how do they work?

It takes approx. 3 minutes to read this article

Despite its inconspicuous size, the oil pressure sensor is an extremely important element of the engine lubrication system, which translates into correct functioning of combustion engine units

The oil pressure sensor is an extremely treacherous element of the engine lubrication system. Failure of this sensor may confuse not only an occasional driver, but also an experienced mechanic – an expert in his profession. The oil pressure sensor is usually mounted above the oil sump. Its task is to monitor oil pressure. Similarly, if the system detects irregularities, you will see a light on the dashboard resembling an oiler

Oil pressure light

In the context of everyday car use, the oil pressure light comes on when the ignition is turned on for system diagnostics. When the test is successful, the light goes out. If the oil pressure light comes on while maintaining a low RPM, it will prove crucial to have the engine component lubrication system checked. Even worse, if the light comes on while maintaining high RPMs, the situation is alarming and the potential problem should be addressed immediately. More often than not, this means an extremely low oil level, a serious leak, or damage to the oil pressure sensor itself

It is important to check that the oil pressure sensor is functioning properly. Not infrequently it turns out that the sensor does not inform about irregularities due to damage or broken wire between it and the indicator. In this case, we should use an ohmmeter, after disconnecting the wire from the sensor, to check the resistance between its tip and the vehicle ground. If the meter indicates only a few ohms, it means that the sensor is defective. If more, the circuit has been broken. Subsequent verification will help find the exact cause of the failure.

Finally, under some conditions, the pressure light may alternately go off and come on. However, this does not mean that it is a cause for concern. If the situation occurs during changes in direction or speed (cornering, sudden braking and acceleration), it may be that the oil level in the oil pan is too low. It is important to top up the oil immediately. The forces acting on the car and the fluids in it cause the suction line and oil pump to draw in air

Pay close attention to the oil pressure light and don’t ignore early warning signs. This is one of the reasons that can negatively affect the technical condition of the drive unit.

(photo.pixabay.com)

Add comment

Your email address will not be published. Required fields are marked *

*

2 + 18 =

Recommended articles
What film to apply to the car body? We suggest
What film to apply to the car body? We suggest
In our country, it is increasingly popular to apply film to the car body. What film should we choose for our car to get the best effect?
Removing rust from your car – step by step
Removing rust from your car – step by step
Have you noticed rust on your car? Don't send your car to a mechanic right away! See how you can remove rust yourself!
Porsche’s fantastic project! They will create a fairy tale car
Porsche’s fantastic project! They will create a fairy tale car
The animated film series "Cars" was an introduction to the automotive world for many young people. Porsche knows this and - to help Ukraine - will recreate one of the characters from these films in the real world.
Latest articles